Nady Systems UIC80PP Manuale Utente

W-1KU1000 Channel UHF Wireless SystemOWNER’S MANUAL

At maximum receiver volume setting, as indicated by the Volume display, the system output is approximately +4dB higher than a direct cord-to-amp conne

11a radio signal on the same channel as the receiver. The Signal Strength and Diversity Indicators on the receiver’s LCD display will then light up, i

be on, indicating a received signal from the transmitter. Adjust the volume of the receiver per Connecting Audio Output. Note: Avoid acoustic feedback

13more at three seconds, indicating that the IR transmission is over. Upon successful data transfer (usually in less than two seconds) the transmitter

14Operating the BT-1KU Bodypack Transmitter During normal operation with the unit powered on, the transmitter power level can be changed by sliding th

15SpecificationsSYSTEM OVERALL SPECIFICATIONSOperating Frequency Range 672MHz-697MHz (US)Freq. Synthesized (1000 channels switchable) 25kHz/stepPLL

16Cautions and TroubleshootingFeedback Avoid acoustic feedback (howling or screeching) by taking care in selecting PA volume, transmitter location and

17Miscellaneous TipsFor optimum operation with external •antennas, low loss RF shielded cable should be used and the length of the cable should not e

18FrequencyFrequency PlanBand 1: 672.000-696.975MHz 25KHz per step (1000 Channels) U.S.AccessoriesPart Number DescriptionIC-U1K Instrument cable in

19One Year Limited WarrantyNady Systems, Inc. warrants to the original consumer purchaser that the unit is free from any defects in material or workma

Contents2Introduction ... 2U

6701 Shellmound Street | Emeryville, CA USA 94608 T 510.652.2411 | F 510.652.5075 | www.nady.com

System FeaturesW-1KU ReceiverUnsurpassed state-of-the-art PLL UHF •performance with 120dB dynamic range and operation up to 500 feet line-of sight100

4Quick User Controls GuideW-1KU Receiver: Front ViewGROUP CHANNEL VOL1 9 1087311 12GROUP CHANNEL VOL3 4 5 621. AF/PEAK LED TREE Shows audio l

131915 16 17 18142021W-1KU Receiver: Back View513. DC INPUT JACK For connecting external AC/DC adapter for powering receiver14. DC POWER SUPPLY UNIT

6Quick User Controls GuideHT-1KU Handheld Transmitter2330313225 27 28 2926IRHLRF22374024383922. BATTERY COVER Unscrew to insert two AA alkaline batte

3433374038 39354344414248464536477Quick User Controls GuideBT-1KU Bodypack Transmitter (LT, LT/HM or GT)33. INPUT JACK 3.5mm locking mini jack for co

Buttons Function The Power Button (12) is used to turn the receiver on or off. When the button is pressed, the lit blue backlight on the LCD Display (

9Installing Antennas Install antennas by connecting the two Antennas (19) included with your system to the two RF Connectors (18) located on the back